Evolution Aqua EAZYPOD AUTOMATIC User Manual

INSTALLATION AND INSTRUCTION MANUAL
Evolution Aqua Ltd. - Evolution House - Kellet Close - Wigan - Lancashire - United Kingdom - WN5 0LP
t +44 (0) 1942 216554 - f +44 (0) 1942 418 489 - e info@evolutionaqua.com - w www.evolutionaqua.com
UK
English
EAZYPODAUTO1250416MAN
IMPORTANT PLEASE READ:
We recommend that all electrical work on your EazyPod
Automatic System be done by a suitably qualified electrician.
Ensure that the UV is switched off at the mains before you attempt
to conduct any type of maintenance.

Evolution Aqua EAZYPOD AUTOMATIC Specifications

General

Brand	Evolution Aqua
Model	EAZYPOD AUTOMATIC
Category	Water Filtration Systems
Language	English

Summary

Important Safety Notes

Qualified Electrician Recommendation

Maintenance Safety Precautions

General Safety Information

Key Safety Instructions

Lists critical safety instructions for operating and maintaining the EazyPod Automatic.

How the EazyPod Automatic Works

Setting Up the EazyPod Automatic

Add K1 Micro Media

Fit the Eazy Connector on the Outlet Pipe

Fit the Non-Return Hosetail

Connect Waste Valve

Installation

Pump Fed Set-up Only

Specifies that the EazyPod Automatic must be installed in a pump fed configuration, not gravity fed.

Pump Placement and Base Requirements

Connection to the Electricity Supply

Electrical Safety and Wiring

Stresses qualified electrician requirement, RCD use, and disconnection procedures before handling.

Connecting UV to Electricity Supply

Guidance for Electrical Connections

Control Box Access and Familiarisation

Re-fitting the Control Box Lid

Guidance for Mains Power Connection

Mains Cable Connection Steps

Step-by-step guide for feeding and connecting the 3-core mains cable (Live, Neutral, Earth) to the control box.

Guidance for Circulating Pump Power Connections

Circulating Pump Cable Connection

Step-by-step guide for connecting the circulating pump's 3-core cable to the control box, emphasizing correct terminal placement.

Cleaning with the EazyPod Automatic

Manual and Automatic Cleaning

Describes how to initiate manual cleaning and the automatic cleaning schedule controlled by the cycle timer.

The Cycle Timer Explained

Cycle Timer Adjustment Guide

Explains the function of screws A and B for setting cleaning cycle frequency and provides a key for timer display symbols.

Setting the Cycle Timer

Adjusting Cleaning Frequency

Instructions on using a screwdriver to turn screws A and B to set the desired cleaning cycle time and frequency.

Cleaning Frequency Settings Tables

Offers tables to configure cleaning frequency for multiple daily cleans, daily cleans, and weekly cleans.

Automatic Cleaning Operation

Automatic Cleaning Cycle Sequence

Details the steps of the automatic cleaning cycle, including water flushing and component actions.

Cleaning the UV Quartz Glass

UV Quartz Glass Cleaning Procedure

Replacing the UV Bulb

UV Bulb Replacement Procedure

Troubleshooting

No Power to Control Box

Automatic Waste Valve Issues