The EazyPod Automatic will control the cleaning cycle fully automatically. During the cleaning
cycle, water is flushed to waste, this will mean that unless the water in your pond is topped up,
the water level will go down.
We recommend that an automatic top up system or
a constant trickle feed be added to your installation
to allow for this. We strongly recommend using
an Evolution Aqua Detox Dechlorinator which will
remove harmful chlorine from your tap water. This
ensures your pond is always topped up even when
you are on holiday.
Cleaning is done on a timer, which is factory set at every 3 days, however, this is easily
adjustable to fit in with your pond requirements. (See “SETTING THE TIMER on page 21”)
The EazyPod Automatic will run a cleaning cycle which lasts approximately 6 and a half
minutes.
*NOTE: If the circulation pump does not switch on, then the waste valve is not fully closed and
you will see both the green and amber lights illuminated. This safety feature is built in to ensure
that you cannot empty your pond.
AUTOMATIC CLEANING OPERATION
■
Adjustable timer kicks in to start a cleaning cycle.
■
The amber light on the control box illuminates.
■
Control box automatically switches circulating pump off.
■
Air pump inside the control box is switched on to clean the K1 Micro media.
■
After the K1 Micro media has been cleaned, the automated waste valve opens.
■
The EazyPod Automatic is drained to waste.
■
The automated waste valve closes. (Both green and amber lights are illuminated)
■
When the waste valve is fully closed, the air pump is switched off.
■
When only the green light is illuminated, the circulating pump switches back on.
■
EazyPod Automatic returns to filtration mode.
0
2
4
6.5
EazyPod Automatic cleaning cycle:
APPROX. CLEANING TIMES (Mins)
22