The EazyPod Automatic is truly multi-functional. It can be run in several different ways for different
applications.
The EazyPod Automatic can be used:
• as a stand alone filter on a small pond
• as a complete filter on a quarantine system
• as a pre-filter at the front of any new or existing system
• as a polisher at the end of any system
• off a mid water feed to aid mechanical filtration
• on a skimmer line as a mechanical filter
Remember that if you use the EazyPod Automatic solely as a mechanical filter,
you will also get an enhanced biological benefit in your system.
EazyPod Automatic Specifications and Flow Rates
Follow this manual carefully and your filter will provide a perfect environment for your fish. One
of the factors that can have a significant influence on our ponds is the turn over rate. This is the
time that it takes for the total water volume of the pond to pass through the filter system once. On
ponds, where an EazyPod Automatic is used as the only filtration system, a total pond volume turn
over of every 1 to 2 hours is required.
Therefore if you have a 10,000 litre pond, a minimum rate of 5,000 litres per hour is needed
giving a 2 hour turnover, although you could also run at 10,000 litres per hour giving a turnover
rate of once per hour.
SPECIFICATION AND FLOW RATES
Max flow rate: 10,000 litres/hr 2,200 UK gallons/hr 2,640 US gallons/hr
Max pond size for all fish
10,000 litres 2,200 UK gallons 2,666 US gallons
Max pond size with
the addition of
supplementary UV
20,000 litres 4,400 UK gallons 5,333 US gallons
K1 Micro 18 litres
Max feed rate 100 - 120g per day
AirPump Factory fitted inside control box
UV Bulb Specification 18 Watt PL-L UV-C
UV Bulb Life Recommended bulb change every 8000 hours
10
To Next Page
Loading...
