CLEANING WITH THE EAZYPOD AUTOMATIC
MANUAL CLEAN
When you push the “MANUAL CLEAN” button a cleaning cycle will begin.
Once initiated, we advise that you allow the cleaning cycle to run from start to finish. However,
in unexpected circumstances by interrupting and restarting the power supply, the system will
reset itself to a zero start condition for all functions (a power cut will have the same effect).
PLEASE NOTE: When you first power up the EazyPod Automatic, a cleaning
cycle will commence.
AUTOMATIC CLEAN
You do not need to push any buttons to start an Automatic Clean.
The frequency of cleaning is factory set to cycle once every three days.
This time period can be easily adjusted by changing the CYCLE TIMER located inside the control box.
Once an Automatic Clean is initiated, we advise that you allow the cleaning cycle to run from start
to finish. However, in unexpected circumstances by interrupting and restarting the power supply,
the system will reset itself to a zero start condition for all functions (a power cut will have the same
effect).
SCREW A
SCREW B
DO NOT
ADJUST
(Covered by label)
THE CYCLE TIMERINSIDE THE CONTROL BOX
NEW
18
To Next Page
Loading...
