SETTING THE CYCLE TIMER
If you do not want to have your EazyPod cleaned once every 3 days, as is factory set, you can alter
the cleaning frequency to suit your needs. Simply turn SCREW A and SCREW B to point to the
different digits using the sequences shown in the tables below:
SCREW A - This screw sets the time of the cycle.
(Factory set pointing to 10 d)
Use a pozi-drive screwdriver to turn the screw head,
so the arrow on the dial points to the appropriate digit.
SCREW B - This screw sets the frequency as a
percentage of the time set above. (Factory set
pointing to 30%)
20
To Next Page
Loading...
