POND
FILTER
EVOUV
MAINS
POWER
LEAD
POND
WATER
PUMP
PUMP
SYMBOL KEY:
DIRECTION OF
WATER FLOW
POSITIONING AND MOUNTING THE evoUV
Gravity Fed Installation
Pump Fed Installation
If installing the unit prior to or without a pond filter, we would recommend the use
of a pre-filter on the water pump to prevent excess solids from being pumped into
the unit. The evoUV may be connected to the water flow on any pumped line, this
could be, for instance, a skimmer line or any other additional pumped line. The two
most common forms of set up are pump fed and gravity fed, shown below:
Most evoUV are designed to take 1½" threaded fittings.
Note: evo110 is 2" plain fittings only.
*If your evoUV will be positioned in a permanently dry environment then it can be
installed in any position.
PLEASE NOTE:
On Gravity Fed systems it is recommended to install a ball valve either side of the
evoUV for maintenance.
POND
WATER LEVEL
PUMP
SYMBOL KEY:
DIRECTION OF
WATER FLOW
BALL VALVE /
SERVICE VALVE
POND
FILTER
WATER
PUMP
EVOUV
MAINS
POWER
LEAD
10
To Next Page
Loading...
