The difference is clear at www.evolutionaqua.com
7
NEXUS310 PUMP FED INSTALLATION
WASTE PIPE CONNECTION
The waste valves are where the waste from your Nexus is discharged when cleaning and
prior to draining. The 1
1
/2” valve is for the Inner Chamber and is used for when cleaning the
Eazy, while the ¾” valve is for draining the outer chamber (only when and if required).
Both of these valves can be connected using a waste pipe kit (optional extra) as shown in
Figs 2.1-2.3 or can just be discharged individually. If the Nexus is located below your drain
height the waste can be either discharged into a sump where a submersible pump can
be used to pump the waste away or an in-line pump can be connected to the waste line
where it can pump directly to waste.
Once your Nexus is installed and plumbed in as described above, you are ready to ll the
Nexus and begin treating your pond water.
OPERATING YOUR NEXUS 310 PUMP FED
Once your Nexus is installed and plumbed in as instructed, you are ready to ll the Nexus
and begin ltering your pond water.
To ll your Nexus rst you need to open the inlet valve. With a pump fed unit you then need
to switch on your pump.
Once the Nexus is full, you will notice that the K1 Media in the outer chamber, will oat on
the surface of the water. In a pond containing sh, the media will begin moving completely
within a week. This is perfectly normal.
Now your Nexus is full it is time to turn on your air pump to circulate the media making sure
the air valve to the outer chamber is open and the valve to the Eazy is closed.
Fig 2.1 Installed Fig 2.2 Exit to left
Fig 2.3 Exit to right
To Next Page
Loading...
