Evolution EVO42 User Manual

6
www.evolutionsteel.com
ELECTRICAL SAFETY - EU ONLY!
WARNING: Operating on a lower than
rated voltage will result in the electro
magnet being at reduced power and the
machine may become insecure whilst cutting.
CONNECTIONOFTHEMAINSPLUG-CLASS1
MACHINES - EU ONLY
This product is fitted with the correct moulded
plug for the designated sales market. The
plug meets the requirements of international
standards, and must be connected to a supply
voltage that is equal to that stated on the
rating label. If the plug or mains supply lead are
damaged they must be replaced with a complete
assembly that is identical to the original. Adhere
to the requirements for mains electricity supply
connectionthatappliesinyourCountry.Ifin
doubt consult a qualified electrician.
CONNECTIONOFTHEMAINSPLUG-CLASS1
MACHINES - UK ONLY
IMPORTANT: The wires in the mains
lead fitted to this product are coloured in
accordance with the following code:
Brown: Live (L)
Blue: Neutral (N)
Green and Yellow
or Green: Earth (E)
THIS PRODUCT REQUIRES
A CONNECTION TO EARTH.
3 PIN PLUG MUST COMPLY TO BS1363/A.
FUSE MUST COMPLY TO BS1362.
If for any reason the moulded 13 amp plug
fitted to this product requires replacement it
must be wired in accordance with the following
instructions:
Connect the Blue wire to the terminal marked
Neutral (N).
Connect the Brown wire to the terminal marked
Live (L).
Connect the Green and Yellow wire to the
terminal marked Earth E
DO NOT CONNECT THE BROWN (LIVE)
OR BLUE (NEUTRAL) TO THE EARTH PIN
MARKED E ON THE 3 PIN PLUG.
Ensure that the outer insulation is gripped by
the cord grip and that the wires are not trapped
when replacing the plug cover.
A 13 amp (BS1362) fuse must be fitted in the
plug.
IF IN DOUBT CONSULT A QUALIFIED
ELECTRICIAN.
There are no user serviceable parts inside except
those referred to in the manual. Always refer
servicing to qualified service personnel. Never
remove any part of the casing unless qualified to
doso;thisunitcontainsdangerousvoltages.
OUTDOOR USE
WARNING: For your protection, if this
tool is to be used outdoors, it should not
be exposed to rain or used in damp locations,
as water entering the power tool will increase
the risk of electric shock. Do not place the tool
on damp surfaces. For added protection use a
residualcurrentdevice(R.C.D.)thatwillinterrupt
the supply if the leakage current to earth
exceeds 30mA for 30ms. Always check the
operationoftheresidualcurrentdevice(R.C.D.)
before using the machine.
If an extension cable is required it must be a
suitable type for use outdoors and so labelled.
These extension cords are rated for outdoor
use and reduce the risk of electric shock. The
manufacturers instructions should be followed
when using an extension cable.
Note: If the mains cable requires replacing it
must be replaced with an identical one and be
fitted by a qualified person.
(These General Power Tool Safety Instructions are
as specified in BS EN 60745-1:2009 & EN 61029-
1:2009)
THIS PRODUCT REQUIRES

Evolution EVO42 Specifications

General

Brand	Evolution
Model	EVO42
Category	Drill
Language	English