Evolution EVO42 User Manual

18
www.evolutionsteel.com
• Correctlypositionthemachineontheworkpiece,withtheelectro
magnet energised and with the safety strap secured in place.
• CheckforsufcientCoolant/Lubricationuidowingatthecutter.
• StartthemotorbyselectingtheONpositionoftheBLACK
switch, located on top of the machine. (refer to Fig.5)
• Usingthefeedhandlesslowlylowerthecuttingheaduntilthe
cutter makes contact with the work piece.
• Continuetoapplyonlysufcientpressuretoallowthecuttertocut
freely through the work piece.
• Dependingonthethicknessoftheworkpieceperiodicallyraise
the cutter to clear the swarf build up prior to continuing the cut.
Note: When fitted, the 3 jaw chuck (and any twist drill fitted
into it) are considerably longer than any of the annular cutters
usually fitted into this machine. To accommodate this greater
overall length the secondary slide facility of the machine must be
employed.
The locking lever for the secondary slide has a left hand thread and
is found on the lower Left Hand side of the gearbox housing. (Fig.
9) Loosen this lever to adjust the height (length) of the machine
(max 670mm) to suit the drilling application.
Once adjustment has been satisfactorily completed, ensure that
the secondary slide is securely tightened using the locking lever.
To fit the chuck:
• Screwthe3jawauxiliarychuckintothethreadedboreofthe
chuck adaptor. (Fig. 10)
• Alignthetwoatsonthechuckadaptorwithoneofthescrews
in the spindle. (Fig.11)
• Starttotightenthegrubscrewandatthesametimeslightly
rotate the chuck adaptor backwards and forwards until the grub
screw is fully tightened. This will ensure that the grub screw is
located squarely onto the flat preventing the chuck adaptor from
becoming loose.
• Tightentheremaininggrubscrew.
MAINTENANCE
Note: Any maintenance must be carried out with the machine
switched off and disconnected from the mains/battery power supply.
Checkthatallsafetyfeaturesandguardsareoperatingcorrectlyona
regular basis. Only use this machine if all guards/safety features are
fully operational.
All motor bearings in this machine are lubricated for life. No further
lubrication is required.
Use a clean, slightly damp cloth to clean the plastic parts of the
machine. Do not use solvents or similar products which could
damage the plastic parts.
Fig. 10
Fig. 11

Evolution EVO42 Specifications

General

Brand	Evolution
Model	EVO42
Category	Drill
Language	English