Evolution RAGE3+ - Page 11

 
Sliding Carriage Locking Screw. (Fig. 7)
Note:
operator mistake etc.) the locating lugs have been tripped
(Fig. 8) the Sliding Carriage cannot be fitted into the
Bevel Neck or onto the Cutting Head until they are reset.
To reset the locating lugs:
 
 
using a flat bladed screwdriver (not supplied). (Fig. 9)
Sliding Carriage
Locking Screw
Fig. 7
Fig. 8
Fig. 9
Lock
11
www.evolutionpowertools.com