Evolution X-Session Advanced User Guide
14
The X-Session uses non-volatile memory so that you can continue where you left off even
after powering down and restarting. The current X-Session controller and channel
assignments are stored whether you have stored your setup to a memory locations or
not. Also stored is MIDI Out from USB on/off, Program, DATA LSB and DATA MSB data,
global channel setting and last used memory preset.
Pressing the MEMORY DUMP buttons will send out a number of Sys Ex data packets
that represent the 10 memories you have set up in your X-Session. This is a useful way
of storing or backing up the contents of your memory presets externally.
You can record the complete memory dump in to a standard sequencer. To recall the
memory dump back to the X-Session, play the MIDI track containing the recorded mem-
ory dump to the X-Session, making sure that the X-Session drivers are selected as
output for that particular track.
The current controller assignments are not affected by a memory dump, or a memory
send to the X-Session. Once a memory dump has been sent to the X-Session, you will
needto recall a preset to access the new memory settings.
Pressing the “DEV. ID” buttons will allow you to assign a Device ID to the X-Session.
The default Device ID is 127, which means when a memory dump is performed, that
dump can be received by any X-Session, regardless of the Device ID setting.
If a device ID is assigned to any number other than 127, the memory dump performed
will be specific to X-Session's with the same device ID. If the device ID of a X-Session
differs from the one recorded with the memory dump, the data will be ignored.
The device ID is a handy way of differentiating between multiple X-Session's.
Otherwise, we recommend you keep the device ID setting as 127.
When you press the Device ID buttons, you will see the small 2-digit display on LCD
display 'id'. The 3-digit display represents the assigned Device ID. You can enter a
new device ID using the numeric keypad, or the '+' and '-' buttons.
For more information on Sys Ex messages and device ID, please go to page 18.
The X-Session comes with 10 useful presets stored in it's memory (for complete list,
see Appendix H). You can reset the X-Session back to the factory defaults on
power-up by holding down the +/- buttons.
Note: Restoring the Factory presets will erase all X-Session setups stored to memory.
Non-Volatile Memory
Memory Dump
Assigning A Device ID To The X-Session
Resetting To The Factory Default Setting
19
Evolution UC-33 Advanced User Guide
The Evolution
Librarian Software
To Next Page
Loading...