Evolution X-Session Advanced User Guide
24
Appendix A - MIDI IMPLEMENTATION CHART
Function Transmitted Received Remarks
Basic :Default
Channel:Changed
1-16
1-16
X
:Default
Mode :Messages
:Altered
---------
X
*********
X
Note
Number:True Voice
0-127
*********
X
Velocity: Note ON
: Note OFF
0
0
X
After : Keys
Touch :Ch’s
0
0
X
Pitch Bend 0 X
Control 0-119
Change
0 X
120-127 0 X
Program
Change:True Number
0-127
*********
X
System Exclusive GM, GM2, MMC
Memory
Dump
Song Position
Common:Song Select
X
X
X
System :Clock
Exclusive:Commands
X
0
X
Aux :Local ON/OFF
Messages :All Notes OFF
:Active Sense
:Reset
0
0
0
0
X
Notes: 0 = YES X=NO
9
Evolution X-Session Advanced User Guide
ASSIGN Description Program
(Press Twice)
Bank LSB (Press
Twice)
Data Msb (Press
Twice)
0-119 Standard MIDI CC’s - Toggle Value 2 Toggle Value 1
120-127 Channel Mode Messages - Toggle Value 2 Toggle Value 1
128 Pitch Bend Sensitivity - Sensitivity value -
129 Channel Fine Tune - Tuning amount -
130 Channel Coarse Tune - Tuning amount -
131 Channel Pressure - Pressure amount -
132 RPN Coarse Value RPN LSB RPN MSB
133 RPN Fine Value RPN LSB RPN MSB
134 NRPN Coarse Value NRPN LSB NRPN MSB
135 NRPN Fine Value NRPN LSB NRPN MSB
136 Master Volume* - Volume LSB Volume MSB
137 Master Pan* - Pan LSB Pan MSB
138 Master Coarse Tune* - Tuning LSB Tuning MSB
139 Master Fine Tune* - Tuning LSB Tuning MSB
140 Chorus Mod rate** - Mod rate -
141 Chorus Mod Depth** - Mod depth -
142 Feedback** - Feedback level -
143 Send to Reverb** - Reverb send level -
144 Pitch Bend - Pitch shift LSB Pitch shift MSB
145 Program/Bank Preset Program Bank LSB Bank MSB
146 MIDI CC (on/off) MIDI CC Button release value Button press value
147 Note (on/off) Note Velocity off Velocity on
148 Note (on/off toggle) Note Velocity off Velocity on
149
MMC Command*** - Command select. -
150
Reverb type ** - Type -
151
Reverb time ** - Time -
152
Chorus type ** - Type -
255
Controller Off****
- - -
Assignable MIDI Buttons
Selecting A Controller For Editing
Before you can assign a MIDI CC to one of the X-Session’s controllers, you will need to
select it for editing. There are 2 methods for doing this:
1. Press CONTROL SELECT. The LCD will display the CONTROLLER symbol.
The symbol will be flashing to indicate the controller settings can be altered. The
3-digit display will show the number of the currently selected controller, proceeded
by a 'C', or an 'F' if the cross fader is selected.
2. Type in the number of the controller using the numeric keypad, or the +/-
buttons.
or
Move the cross fader/rotary controller.
Simply moving a fader/rotary controller will make it the currently selected
controller, ready for editing.
To select the second cross fader controller value (F18) please use method 1.
It is also not possible to select any of the 10 numerical buttons by pressing them,
since during edit mode, they are used to enter numerical values. To program these
buttons, please use the first method.
To Next Page
Loading...