What to do if Evoqua Controller indicates input under-voltage?
If the AC input voltage to your Evoqua Controller G2 drops below 726 V, the DC power stage will restart. However, if this happens three times within 30 minutes, the DC power stage will shut down. To restart it, you'll need to manually cycle the AC input power to the controller off and then on again.
General| Brand | Evoqua |
|---|---|
| Model | IONPURE IP-POWER600-G2 |
| Category | Controller |
| Language | English |
Highlights critical information using WARNING and CAUTION labels to ensure safety.
Provides an overview of the DC power controller, its function, ratings, and capabilities.
Details procedures and environmental considerations for physically installing the power controller.
Covers requirements for connecting the AC power source, including transformer and protection.
Explains how to correctly connect high voltage AC input and DC output terminals.
Describes the function of DIP and rotary switches for configuration and selection.
Outlines guidelines for analog signal wiring and low voltage control connections.
Details the sequence for starting up the CEDI system with the power controller.
Explains how to adjust the DC output current based on changing operating conditions.
Provides a matrix to diagnose fault conditions based on LED indicators on the circuit board.
Discusses key design considerations for selecting and using an isolation transformer.
Covers essential components like fuses, circuit breakers, snubbers, enclosures, and contactors.
Details the UL recognition standards for the power controller in North America.
Outlines compliance with EMC and Low Voltage Directives for the European market.
To Next Page
