5. Once the upgrade script has ended successfully (failed:0), if you used a USB key,
please unmount it before removing it from the machine:
cd
sudo umount /media/BOOT
sudo rmdir /media/BOOT
GUIProcedure
Please follow the procedure as described in the popup.
Reboot the Machine
Reboot the machine and wait for a few minutes before starting the Client:
• If you are upgrading an X-One server, please wait for 2-3 minutes and open the
Services Management tool: http://127.0.0.1:9081 to check if everything is ok
on the Health page (green or at least orange status for the resolv.conf check) before
starting to use X-One.
• If you are upgrading an X-One Client, the Services Management page is not present,
so please just wait for 30 seconds to be sure everything has started before beginning
to use X-One.
INSTALLATION AND CONFIGURATION MANUAL X-One 1.7
3. Installation 7
To Next Page
Loading...