2.2.5 MASTER / SLAVE SWITCH
A XHub3 can be set as the master by moving the switch up to MASTER. To set a
XHub3 as slave, move the switch down to SLAVE. Refer to section 2.4
‘Interconnecting XHubs’ on page 7 for more information.
2.2.6 VERSION SWITCH
The Version switch allows the identification of the Xhub3 software version. When
the switch is moved up, it is in Version Detection mode. When it is moved down, it
is in normal operation mode. Refer to section 3.1 ‘Identifying the XHub Software
Version’ on page 9 for more information.
To Next Page
Loading...