4. Operation & Use
4.1 Preparation for fi rst use
When the wiper has been installed and adjusted, the system can be prepared for fi rst use.
We recommend a thorough inspection of the system to ensure proper operation.
Check:
• there are no leaks where the shafts go through the bulkhead;
• the wiping arc cleans the entire window;
• the park position is correct.
If the wiping arc or the park position is wrong, adjust them again. Follow the procedure in
paragraph 5.3.
4.2 Normal operation
All Exalto windscreen wipers are provided with the following functions:
• low speed;
• high speed;
• self parking.
Do not use the wiper on a dry window; excessive wear of the blades and the motor will
occur in this case. Because of the wide variety of wiper switches, refer to the user manual
for the installed switch to learn about the functions of that specifi c switch. In the back of
this manual you will fi nd some general controls and its wiring instructions.
12
MANUAL WIPER SYSTEMS
To Next Page
Loading...
Need help?
General
