124505 3-5 REV A
12. Raise the deck discharge chute to the full up position
(90
o
) and slide the outlet tube into position.
It will be necessary to force the discharge chute to the
90
o
position. The chute will contact the mower fender
before the 90
o
position is attained. Push on the
discharge chute until the chute is open enough to allow
the tab of the outlet tube to be inserted into the slot in
the discharge chute bracket of the deck. The downward
spring force of the discharge chute helps to secure the
outlet tube to the deck by locking the bump on the outlet
tube with the cams of the discharge chute. Figure 3-8 &
Figure 3-9
Secure the outlet tube in place with the bungee latches.
Figure 3-5
A. Discharge chute
B. Outlet tube
C. Bungee latch
D. Tab
E. Chute stop
Figure 3-5
A. Tab B. Discharge chute
Figure 3-6
A
D
C
E
B
C
B
A
A. Hammer
B. Screwdriver
C. Tab
Figure 3-7
Outlet Tube Tab Not Installed Correctly
A. Discharge chute
B. Outlet tube tab
C. Discharge chute
bracket slot
Figure 3-8
A
B
C
C
A
B
To Next Page
Loading...