M100135Copyright © 2011 MAT Industries, LLC 10 - ENG
OPERATING INSTRUCTIONS (CONT.)
• SAVE ALL INSTRUCTIONS
HOW TO APPLY CHEMICALS
AND CLEANING SOLVENTS
Applying chemicals or cleaning solvents is a low pressure
operation.
NOTE: Use only soaps and chemicals designed for pres-
sure washer use. DO NOT USE BLEACH.
To Apply Chemicals:
1. Make sure the chemical hose is
pressed onto the barbed tting located
near high-pressure hose. (Fig. 8)
2.
The other end of the chemical hose
should be connected
to the nipple on
the bottom of the chemical tank.
(Fig. 9)
NOTE: For every 7 gallons of water pumped 1 gallon of
chemical/cleaning solution will be used.
3. Fill chemical tank with appropriate cleaning solution.
4. Insert chemical nozzle into spray wand, see Use Spray
Wand paragraph in this section.
NOTE: Chemicals and soaps will not siphon when us-
ing any quick connect nozzle other than the black soap
nozzle.
WARNING
To reduce the risk of injury, read the pressure washer instruction manual and the
engine instruction manual before starting pressure washer.
DANGER
RISK OF FLUID INJECTION AND LACERATION. When using the high-pressure setting, DO NOT
allow the high-pressure spray to come in contact with unprotected skin, eyes, or with any pets or animals. Serious
injury will occur.
• Your washer operates at uid pressures and velocities high enough to penetrate human and animal esh, which
could result in amputation or other serious injury. Leaks caused by loose ttings or worn or damaged hoses can
result in injection injuries. DO NOT TREAT FLUID INJECTION AS A SIMPLE CUT! See a physician immediately!
WARNING
RISK OF FIRE, ASPHYXIATION AND BURN. NEVER ll fuel tank when engine is running or hot.
Do not smoke when lling fuel tank.
• NEVER ll fuel tank completely. Fill tank to 1/2” below bottom of ller neck to provide space for fuel expansion.
Wipe any fuel spillage from engine and equipment before starting engine.
• NEVER run engine in doors or in enclosed, poorly ventilated areas. Engine exhaust contains carbon monoxide, an
odorless and deadly gas.
• DO NOT let hoses come in contact with very hot engine mufer during or immediately after use of your pressure
washer. Damage to hoses from contact with hot engine surfaces will NOT be covered by warranty.
CAUTION
RISK OF PROPERTY DAMAGE. NEVER pull water supply hose to move pressure washer. This
could damage hose and/or pump inlet.
• DO NOT use hot water, use cold water only.
• NEVER turn water supply off while pressure washer engine is running or damage to
pump will result.
• DO NOT stop spraying water for more than two minutes at a time. Pump operates in bypass mode when spray
gun trigger is not pressed. If pump is left in bypass mode for more than two minutes internal components of the
pump can be damaged.
If you do not understand these precautions, please call 1-888-895-4549 to speak to a service representative for
further instructions
Barbed
Fitting
FIG.8
FIG. 9
To Next Page
Loading...
Need help?
General
