Copyright © 2011 MAT Industries, LLCM100135 13 - ENG
4. Add RV antifreeze or windshield washer uid to hose
as shown. (Fig. 14)
5. Pull engine starter rope slowly several times until
antifreeze/ washer uid comes out of high-pressure
hose connection of pump.
6. Remove garden hose from water inlet of pump.
7. Reconnect spark plug wire.
STORAGE
• SAVE ALL INSTRUCTIONS
ENGINE
Consult the Engine Owners Manual for the manufacturer’s
recommendations for storage.
PUMP
The manufacturer recommends using a pump protector/
winterizer when storing the unit for more than 30 days and/
or when freezing temperatures are expected. If a pump
protector/winterizer is not available, RV antifreeze or wind-
shield washer uid needs to be run through the pump as
outlined in the steps below.
NOTE: Using a pump protector/ winterizer, RV antifreeze
or windshield washer uid is to provide proper lubrication
to the internal seals of the pump regardless of tempera-
ture or environment.
1. Obtain a funnel, 6 oz. of RV antifreeze or windshield
washer uid, and 16–36” of garden hose with a male
hose connector attached to one end.
CAUTION
RISK OF PROPERTY DAMAGE. Use only
RV antifreeze. Any other an ti freeze is corrosive and
can damage pump.
2. Disconnect spark plug wire.
3.
Connect length of garden hose to water inlet of pump.
REPAIRS
• SAVE ALL INSTRUCTIONS
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be performed by an Autho-
rized Warranty Service Center. Always use identical replacement parts. For the location of the nearest Authorized War-
ranty Service Center call 1-888-895-4549 or visit our website www.powermate.com.
FIG. 14
To Next Page
Loading...
Need help?
General
