Excelta IntelliTweeze TM-500 - Page 15

13
AUTOMODE:Select AUTO mode (AM sign appears at the
left bottom corner of display) for automatic measurement
of inductance, capacitance or resistance.
Note: In the AUTO mode IT uses 1kHz test frequency by
default and has a limited sensitivity. Automatic detection
may not work for small value capacitors and inductors.
In this case 10kHz test frequency must be used..
RESISTANCEMODE:Enables Resistance measurement mode.
See section MEASUREMENT FEATURES for more information.
INDUCTANCEMODE:Enables Capacitance measurement mode.
See section MEASUREMENT FEATURES for more information.
CAPACITANCEMODE:Enables Capacitance measurement mode.
See section MEASUREMENT FEATURES for more information.
IMPEDANCEMODE:Enables the Impedance measurement mode.
Note: See section MEASUREMENT FEATURES for more information.
ESRMODE:Enables the ESR measurement mode. See section
MEASUREMENT FEATURES for more information.
DIODETESTMODE:Enables diode test mode showing
diode polarity or SHORT indicating a faulty diode
DCRMODE:Enables DCR resistance measurement mode.
The DCR measurement measures the resistance of an
unknown component by applying DC voltage.