6
POWERON
POWER-ON-To turn the IntelliTweeze ON,
press the navigation switch twice.
Note: Once powered on, the unit will perform
the last selected function.
POWER-OFF - IT powers off automatically if neither a
measurement is performed nor the navigation control is
operated for approximately 30 seconds (default value).
The power off timeout value can be set by changing
the TIMEOUT setting in the SYSTEM menu.
The default power-off timeout is 30 seconds in a
measurement mode and 30 seconds in the MENU mode.
Note: Automatic power-off does not occur if test
frequency is manually set to 10kHz.
DISPLAY
The screen is divided in four areas:
UP – change test ranges
DOWN – change test signal levels
LEFT/RIGHT – change measurement modes
• Primary Display
• Secondary Display
• Test Parameters
• Device Status with
Test Mode Indicator
PRIMARY DISPLAY
SECONDARY DISPLAY
TEST MODE
BATTERY INDICATOR
To Next Page
Loading...