Adjusting the Rear Stabilizer End Cap or Adjustable Leveler
Turn the rear stabilizer end cap on the rear stabilizer or adjustable leveler on the bottom
of the rear main frame as needed to level the recumbent bike.
Adjusting the Seat Forward or Back
Loosen both side and bottom triangle knobs from the rear main frame. Turn the L
shape knob in a counterclockwise direction until it can be pulled out. Pull out the L
shape knob and then slide the back and seat support bracket back or forth direction to
the suitable position. Lock the back and seat support bracket in place by releasing
the L shape knob and sliding the back and seat support bracket back or forth slightly
until the L shape knob "pops" down into the hole of the seat sliding tube. Finally
tighten the L shape knob and side/bottom triangle knobs in a clockwise direction.
NOTE: When adjusting the seat back or forth direction, make sure the bushing
does not exceed the mark line on the seat sliding tube.
ADJUSTMENTS
25
Rear Stabilizer End Cap
Adjustable Leveler
Side Triangle Knob
L Shape Knob
Bottom Triangle Knob
To Next Page