20
MAINTENANCE
Cleaning
The bike can be cleaned with a soft clean damp cloth. Do not use abrasives or solvents on the
plastic parts. Wipe your perspiration off the bike after each use. Be careful not to get excessive
moisture on the console display panel as this might cause an electrical hazard or electronics to fail.
Keep the bike, especially the console console out of direct sunlight to prevent screen damage.
Inspect all of the assembly bolts, nuts, screws, and pedals on the machine for proper tightness
every week.
Storage
Store the bike in a clean and dry environment away from children and pets.
TROUBLE SHOOTING
PROBLEM: There is no display on the console.
SOLUTION: Remove the console and verify the wires that come from the console are properly
connected to the wires that come from the frame.
SOLUTION: Check if the batteries are correctly positioned and the battery springs are in proper
contact with the batteries.
SOLUTION: The batteries in the console may be dead. Replace the dead batteries with new
batteries.
PROBLEM: There is no heart rate reading or the heart rate reading is erratic or inconsistent.
SOLUTION: Make sure that the wire connections for the hand pulse sensors are
securely connected.
SOLUTION: To ensure the pulse readout is precise, always hold on to the handlebar grip sensors
with two hands.
SOLUTION: Avoid gripping the hand pulse sensors too tightly. Try to maintain moderate pressure
while holding onto the hand pulse sensors.
To Next Page