28
FOLDING THE INVERSION TABLE
For your storage convenience, the inversion table can be folded down to place against a wall,
under a bed, or in a storage area.
1. Pull out the Ring Pin (26) from the holes on the Rear Frame (8) and Front Frame (9). Fig. J
2. Push the Rear Frame (8) and Front Frames (9) together all the way. Fig. K
3. Insert the Ring Pin (26) back into the hole on the Front Frame (9). Fig. L
Reverse the steps to set up the inversion table when you want to use it.
MAINTENANCE INSTRUCTIONS
You should check your inversion table for any kind of wear and tear before each use.
1. Check the pivot arms, backrest, and heel holders for wear and tear.
2. Replace any damaged and worn components immediately.
3. Keep all damaged equipment out of use until it is repaired or replaced.
4. Tighten all loose hardware, bolts, nuts, and caps before using the inversion table.
To Next Page
Loading...
