23
THE HANDLEBARS
For added convenience and safety, a set of Handlebars (6) has been added to the inversion table. These Handlebars
(6) are located at the top of the Rear Frame (8). The Handlebars (6) are there to help you return to the upright
position from any degree of inversion. If you wish to return to the upright position, and the backrest is moving too
slowly, or not moving at all, slowly pull on the handlebars until you return to the upright position.
NOTE: The inversion table should always return to the upright position when you move your hand's closer to your
starting position along the handlebars. If it does not, get off the inversion table and adjust the height setting before
your next use.
WARNING: Invert slowly; failure to comply could result in serious physical injury.
To Next Page
