What to do if Exide Inverterz Star 12V 700VA shows overload indication and no output voltage?
If your Exide UPS indicates an overload and there's no output voltage, it means that there is an excess load applied. Reduce the load on the Exide Inverterz and reset it using the ON/OFF switch.
How to fix Exide UPS with no output voltage and no indication?
If your Exide UPS has no output voltage and no indication, the issue might be due to poor battery condition or a loose battery connection. Try using a new battery or ensure that the battery connections are properly secured.
Why is my Exide UPS not charging when mains are ON?
If the mains are on but your Exide UPS isn't charging, the UPS/Normal selection switch may be in UPS mode. Check the mains voltage and ensure the Normal/UPS mode is selected according to the specified voltage range.
What does continuous beep on Exide Inverterz Star 12V 700VA UPS mean?
A continuous beep on your Exide UPS indicates that the circuit breaker has tripped. Reset the circuit breaker to resolve this issue.
What to do if all LEDs are blinking and there is no output voltage on Exide UPS?
If all the LEDs are blinking and there's no output voltage on your Exide UPS, it suggests a thermal shutdown. Call the service support, as there is an overheat problem in the system.
General| Model | Inverterz Star 12V 700VA |
|---|---|
| Capacity | 700 VA |
| Waveform | Square Wave |
| Output Voltage | 230V |
| Battery Type | 12V |
| Backup Time | Varies based on load |
| Warranty | 2 years |
To Next Page