2 UPS Control Panel
Powerware
®
Plus 12 Operator's Manual (164200090 Rev E) 10
The Active Alarms option displays a description of each active alarm.
The Battery Data option displays information about the battery. If the UPS is running
with normal utility, the Battery Charge bar chart is displayed. If the UPS is running on
battery, the Battery Time Remaining bar chart is displayed. Each block on the bar chart
represents approximately 10% of the total time. This calculation assumes a constant
load on the UPS. If custom batteries are selected, the battery voltage is displayed.
The S. W. Versions option displays the software versions for the front panel, inverter,
and rectifier.
Select the System Setup option to enter the System Setup Menu. This menu is
passwordĆprotected and prompts you for the System Setup password. After entering a
valid password, the System Setup Menu appears.
The default password is MEMORY. It is recommended to change the default
password to ensure security (see page 13). Contact your field service
representative if you have misplaced your password.
The System Setup Menu
From the System Setup Menu, use the Menu button to return to the Main Menu. When
altering settings under the System Setup Menu, the Select button saves a change and
the Menu button cancels the change (unless otherwise indicated). An asterisk (*)
displayed on the left side of the item indicates that the item is currently selected.
The System Setup Menu contains the following options:
1. Select Type
2. H. W. Modules
3. Sync Range
4. Adj Out Volts
5. Comm Setup
6. Relay Setup
7. Set Language
8. Set Time & Date
9. Contrast Adj
10. Horn Volume
11. Clr Alarm Queue
12. Set User PWD
13. Battery Cfg
Use the up and down arrow buttons to display the System Setup options. Press the
Select button to enter one of the submenus.
To Next Page
Loading...