EasyManua.ls Logo

Exide powerware plus - Page 4

Exide powerware plus
64 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
 
Powerware
®
Plus 12 Operator's Manual (164200090 Rev E)ii
 To fully deĆenergize the UPS, turn off the output breaker. Then turn off the
input breaker and the battery breaker.
 Risk of electrical shock. Installation of battery cabinets must be done by
trained service personnel.
 Do not dispose of battery or batteries in a fire. The battery may explode
when exposed to flames.
 Do not open or mutilate the battery or batteries. Released electrolyte is
harmful to the skin and eyes and may be toxic.
 All cabinets must be secured to keep them from moving after installation
is complete. Secure the cabinets by bolting the cabinets to the cabinet mounting
plate. Failure to do so violates safety rules and results in the unit losing its safety
agency approvals.
 A battery can present a risk of electrical shock, burn from high
shortĆcircuit current, fire, or explosion from vented gases. Observe proper
precautions.
 Proper disposal of batteries is required. Refer to your local codes for
disposal requirements.
 Une batterie peut présenter un risque de choc électricque, de brûlure
par transfert d'énergie, d'incendie ou d'explosion des gaz dégagés. Suivre les
précautions qui s'imposent.
 L'élimination des batteries est règlementée. Consulter les codes locaux
à cet effet.
Observe the following precautions to ensure personnel safety and continued
equipment operation:
Examine the packing container for damage. Notify the carrier immediately if
damage is present.
Do not disassemble the UPS.
Do not operate near water or excessive humidity.
Install in a wellĆventilated area. Do not block the air vents.
Do not operate near gas or electric heat sources, and avoid direct sunlight.

Related product manuals