109-4336 Rev. A
Page 1 of 4
Loose Parts
Note: Use the chart below to verify that all parts have been shipped.
109-4333 Dealer Literature Pack
Part # Description Qty Use
323-8
98-5975
3290-357
283-69
1-323142
Cap Screw, Hex 3/8-16 x 1-1/2
Washer, Belleville
Nut, Hex Flange 3/8-16
Pin, Clevis 1/2 x 3-1/2
Nut, Push 1/2
8
8
8
2
2
Installing the Rollover Protection System (Roll Bar)
103-1309 Warranty Registration Form 1 Fill out and return to Exmark
103-2106
1-603511
Key, Exmark Ignition
Key, Standard Ignition
1
1
Unit ignition
109-4332 Literature Pack
Part # Description Qty Use
------------
------------
109-3498
Manual, Operator’s
Manual, Parts
DVD, Exmark Safety Video
1
1
1
Read and view before operating machine
110-3850 Manual, Engine Operator’s 1 For Units with Kubota Engines
Installing the Rollover Protection
System (Roll Bar)
For Units with the roll bar shipped loose:
1. Remove sides and top of crate from the base.
2. Remove roll bar components from the crate.
3. Remove roll bar tubes from sides of crate.
4. Locate the left and right lower roll bar tubes.
5. Align lower bar tubes along rear engine frame
6. Loosely install four 3/8-16 x 1-1/2 capscrews, four
spring disc washers, and four 3/16-18 whizlock
nuts to secure the rollbar to the frame of the unit.
(Fig. 1)
NOTE: Be sure the spring disk washer cone is
installed towards the head of the capscrew.
FIGURE 1
FRONTRUNNER™ DIESEL
SETUP INSTRUCTIONS
For Serial Nos. 670,000 and Highe
To Next Page
Need help?
General
