EasyManua.ls Logo

Exmark Frontrunner 720,000 & Higher Serial Nos. - User Manual

Exmark Frontrunner 720,000 & Higher Serial Nos.
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
FRONTRUNNERTM
AIR-COOLEDMODELS
ForSerialNos.
720,000&Higher
PartNo.4500-218Rev.A

Table of Contents

Questions and Answers

  • C
    crystal33Jul 29, 2025
    Why won't my Exmark Frontrunner 720,000 & Higher Serial Nos. Lawn Mower engine start?
    • S
      suttonkevinJul 29, 2025
      If your Exmark Lawn Mower engine won't start, starts hard, or fails to keep running, several factors could be the cause. First, ensure the fuel tank is full and the fuel shutoff valve is open. Check the oil level in the crankcase and add oil if it's low. Make sure the throttle and choke are correctly positioned. Other potential issues include a dirty fuel filter (replace it), a dirty air cleaner (clean or replace it), corroded or loose electrical connections (check and clean them), a faulty spark plug (clean, adjust, or replace it), or a disconnected spark plug wire (check the connection). If these steps don't resolve the issue, consider contacting an Authorized Service Dealer.
  • M
    mtuckerAug 3, 2025
    What to do if Exmark Lawn Mower starter does not crank?
    • K
      Kelly StevensAug 3, 2025
      If the starter on your Exmark Lawn Mower doesn't crank, there are several things you can check. First, make sure the PTO is disengaged and the parking brake is set. Ensure the drive levers are in the neutral lock position. Check the battery charge and charge it if necessary. Inspect electrical connections for corrosion or looseness; clean and reconnect them. Also, check if a fuse is blown and replace it if needed. If the problem persists, it could be a defective relay or switch, in which case you should contact an Authorized Service Dealer.
  • J
    Johnny LewisAug 7, 2025
    Why is my Exmark Lawn Mower engine losing power?
    • M
      Mr. Timothy EricksonAug 7, 2025
      If your Exmark Lawn Mower engine loses power, it could be due to several reasons. Start by reducing the ground speed, as the engine load might be excessive. Check the air cleaner and clean or replace it if it's dirty. Also, verify the oil level in the crankcase and add oil if needed. Make sure the cooling fins and air passages for the engine are not blocked; remove any obstructions. Check the fuel cap vent hole and clean or replace the fuel cap if the vent hole is plugged. Replace the fuel filter if it's dirty. If the problem persists, contact an Authorized Service Dealer.
  • R
    richard81Aug 11, 2025
    What causes abnormal vibration in Exmark Frontrunner 720,000 & Higher Serial Nos.?
    • L
      Linda WilsonAug 11, 2025
      If you notice abnormal vibration in your Exmark Lawn Mower, start by tightening the engine mounting bolts. Also, check for any loose engine pulley, idler pulley, or blade pulley and tighten the appropriate pulley. If the engine pulley is damaged, contact an Authorized Service Dealer.
  • E
    Eric WilsonAug 15, 2025
    How to fix Exmark Frontrunner 720,000 & Higher Serial Nos. when engine overheats?
    • L
      larry73Aug 16, 2025
      If your Exmark Lawn Mower engine is overheating, consider the following: Reduce the ground speed, as the engine load may be too high. Check the oil level in the crankcase and add oil if it's low. Ensure that the cooling fins and air passages for the engine are free from obstructions; remove any debris.
  • M
    Mark PrinceAug 19, 2025
    What to do if Exmark Frontrunner 720,000 & Higher Serial Nos. does not drive?
    • M
      Michael HarrisAug 19, 2025
      If your Exmark Lawn Mower doesn't drive, make sure the bypass valve is closed tightly. Inspect the drive or pump belt for wear, looseness, or breakage, and change the belt if necessary. Also, check if the drive or pump belt is off a pulley and change the belt. Replace any broken or missing idler springs. Ensure the hydraulic fluid level is adequate and not too hot; add fluid or allow it to cool down if necessary.
  • R
    Ryan DiazAug 25, 2025
    How to stop Exmark Frontrunner 720,000 & Higher Serial Nos. from pulling to one side?
    • R
      Robin CortezAug 25, 2025
      If your Exmark Lawn Mower pulls to the left or right when the levers are fully forward, you may need to adjust the tracking. Also, check and adjust the tire pressure in the drive tires. Another possible solution is to adjust the reverse indicator and the motion control linkage.

Summary

Safety

Safety Alert Symbol

Explains the meaning and usage of the safety alert symbol.

Safe Operating Practices

Outlines essential practices for safe operation of the mower.

Gasoline Safety Warnings

Details dangers and health hazards associated with gasoline.

Operational Safety Precautions

Covers hot parts, CO hazard, tip-over, and entanglement risks.

Slope Operation Guidelines

Safety advice for mowing on slopes.

Rollover Protection System (ROPS)

Information on using and maintaining the ROPS.

Roll Bar Safety

Warnings and precautions when the roll bar is down.

Mechanical Hazard Warnings

Covers rotating blades, spring mechanisms, and slope risks.

Specifications

Operation

Starting the Engine

Step-by-step guide on how to start the engine.

PTO Engagement and Disengagement

Explains how to engage and disengage the PTO and cutting blades.

Maintenance

Cleaning Procedures

Troubleshooting

Starter and Engine Starting Problems

Lists causes and corrective actions for starting issues.

Engine Performance Issues

Lists causes and actions for engine power loss or overheating.

Operational Issues

Lists causes and actions for driving, steering, and vibration problems.

Warranty Information

Exmark Frontrunner 720,000 & Higher Serial Nos. Specifications

General IconGeneral
Drive SystemHydrostatic
Turning RadiusZero-turn
Cutting Height1.5 - 5 inches
Reverse Speed5 mph
Deck TypeFabricated

Related product manuals