23
TRIGGER SENSITIVITY:
This option allows you to adjust the distance/sensitivity
of the detection circuit. NOTE: This setting should remain
on high except for specific use cases that require less PIR
trigger events.
IR FLASH RANGE:
This option allows you to adjust the Flash distance/intensity.
NOTE: This should remain on high for optimal night time
photos/videos. If camera will be used in close proximitiy to
desire target area it then can be adjusted.
TIME LAPSE:
In this option you can setup the interval between photos
that you want the camera to take in time lapse mode.
You can customize intervals from 10 seconds to 23 hours
59 minutes and 59 seconds when the wireless network
is turned off. When the wireless network is turned on
customization is from 1 min to 23 hours 59 minutes and 59
seconds. You can also turn the PIR sensor ON or OFF within
Time Lapse mode here.
SET CLOCK:
This setting allows you to operate the camera inside a
specific time period by selecting “ON” and programming
a Start and Stop time. In the “OFF” position the camera
operates 24 hours continuously without turning off.
To Next Page
Loading...
