25
COORDINATES:
In this option, you can enter the coordinates of your camera
and it will enable GPS geotagging of your photos.
FORMAT:
Formatting is recommended everytime that you insert a SD
card into the camera. It gets the card setup for use inside
the camera, however it will erase any images already stored
on the card.
DEFAULT SET:
Selecting “yes” will reset the camera back to the factory
default settings.
FIRMWARE:
In this option by seletion version the camera will display the
current operating FW installed. To perform a manual FW
update simply select update when FW is properly installed
to a SD card. Manual FW updates are not recommended
for this camera. Any damage or malfuction associated with
manual FW updates will not be covered under warranty,
any maintenance/repairs performed by Exodus will be
subject to a service fee. Updates should be done with OTA
commands when applicable.
To Next Page
Loading...
