Exor eSMART07M - Cleaning Faceplates; Getting Started

22
MANUGENESMARTxx - Version 2.01
© 2018 EXOR International S.p.A. - Subject to change without notice
The equipment must be cleaned only with a soft cloth and neutral soap product. Do not use solvents.
eSMART HMI products must be programmed with the software JMobile Studio (starting from v2.00). JMo-
bile Studio is a software tool that must be properly installed on a computer running Microsoft Windows.
There are two options to transfer a JMobile application project to a HMI device:
Ethernet Connect the HMI device to the computer with an Ethernet network connection. From
JMobile Studio choose the command Run/Download to target. You may have to ensu
re that the proper rewall policy has been congured in the computer to allow JMobile
Studio to access the network.
USB Create an Update Package using JMobile Studio and copy it to a USB Flash drive.
7 Cleaning faceplates
8 Getting Started