ENG
Pinless Moisture Meters
MC-60CPA
Manual
ENG
- 6 -
THIN MATERIALS
For single materials, thinner than 10 mm, the sensi vity of the meter is nor-
mally not enough. However, comparing measurements to determine wet spots
in the material can s ll be performed.
To obtain a more accurate measuring result we recommend measurements in a
pile without air spaces between the single parts and with a minimum thickness
of 20 mm for the pile.
BASE
With material thickness < 50 mm the base material is very important To avoid a
metal base. The best results are achieved if the material to be measured is held
into the air. Polystyrene material with a minimum thickness of 20 (8”) cm can
also be used when using the Measuring Springs.
WET SURFACES
In case of material with a wet surface a PVC-foil can be used between
the material and measuring springs.
REFERENCE MEASUREMENT
How to locate wet spots:
Set the Material code to C1 or P1.
Hold the spring electrodes to a surface you know is dry.
The received value corresponds to a “dry material” and could be used
as reference value.
Now it is possible to locate moist and leakage using the reference value.
By moving the measurement springs over the surface you could quickly
locate the leakage and fi nd out about the extent of the moist damage.
1.
2.
3.
4.
5.
To Next Page
Loading...
Need help?
General
