GETTING STARTED
INSERT BATTERIES
1. Remove the battery door from the back.
2. Insert 2x AAA (LR03)/1.5V batteries. Please ensure the polarities (+/-) of the batteries match
upon installation.
3. Reattach the battery door.
NOTE: Replace batteries when the display is dim.
CLOCK
CLOCK RECEPTION
1. When you insert or replace the batteries, RCC reception is initiated. To manually start RCC rece-
ption, press and hold the [ ] button.
2. If the RCC receiving process is successful, a completed RCC symbol [ ] will be shown in the
display and the date and time will be set automatically. If it fails, press and hold the [ ] button
to re-initiate RCC receiving.
3. If the device is still not receiving the signal, please proceed to set the time manually.
SET THE CLOCK MANUALLY
1. Press and hold [ ] button to enter into time and date setting.
2. The setting parameter will flash.
3. Press [ ▲ ] button once, the figure will increase 1 unit. Press and hold the [ ▲/CF ] button, the
figures will increase rapidly.
4. Press [ ▼ ] button once, the figure will decrease 1 unit. Press and hold the [ ▼/RCC ] button, the
figures will decrease rapidly.
7
EN
IT
DE
FR
ES
NL
To Next Page
Loading...
