Explore Scientific RDP1003-CM3000 - Getting Started; Clock Reception

32
GETTING STARTED
INSERT BATTERIES
1. Remove the battery door from the back.
2. Insert 2x AAA (LR03)/1.5V batteries. Please en-
sure the polarities (+/-) of the batteries match upon
installation.
3. Reattach the battery door.
NOTE: Replace batteries when the display is dim.
AC/DC POWER ADAPTER
4
Only use a compatible AC/DC Power adapter (5V
4
1000mA). Plug the power cable to the power
jack and the power adapter to a suitable power outlet.
NOTE: Batteries are still needed to power the device.
USB CHARGING PORT
The USB charging port allows you to charge USB de-
vices like Smartphones or MP3 Player.
CLOCK
CLOCK RECEPTION
1. When you insert or replace the batteries, RCC recep-
tion is initiated. To manually start RCC reception
press and hold [
] button.
2. The receiving process duration is 7 minutes.
3. During receiving process, the RCC signal symbol
[
] ashes.
4. If the RCC receiving process is successful, a com-
pleted RCC symbol [
] will be shown in the display
and the date and time will be set automatically. If it
fails within 7 minutes, RCC setting will quit automati-
cally. If that happens, press and hold [
] but-
ton to re-initiate RCC receiving.
5. To stop RCC reception, press and hold the
[
] button.
6. If the device is still not receiving the signal, please
proceed to set the time manually.
NOTE: When using a power adapter, please increase
the separation of the main unit and the power adapter
to avoid interference of RCC signal receiving.