What to do if my Expobar Coffee Maker does not start up?
If your Expobar Coffee Maker doesn't start, first ensure the plug is correctly inserted into a working power socket. Next, check that the circuit breaker and/or differential are connected. If the issue persists, the cable or plug may be damaged, and you should call service personnel to replace them.
Why is coffee dispensing so slow on my Expobar Coffee Maker?
If the coffee dispensing from your Expobar Coffee Maker is very slow, it's likely that the coffee grinding is too fine. Adjust the coffee-grinding setting to a coarser level.
How to fix fast coffee dispensing on Expobar Coffee Maker?
If coffee dispensing from your Expobar Coffee Maker is happening too quickly, the coffee grinding is probably too coarse. You should adjust the coffee-grinding setting to a finer level.
What to do if there's water under my Expobar Markus 2GR?
If you find water underneath your Expobar Coffee Maker, it's likely that the drainage tube is blocked. You should clean the drainage tube to resolve this issue.
Why is the steam wand not working on my Expobar Coffee Maker?
If the steam wand on your Expobar Coffee Maker isn't dispensing steam, it's probably clogged by milk. Clean the wand. If necessary, remove the nozzle and unclog it using a pin or needle.
Defines four notification intensity levels: DANGER, WARNING, IMPORTANT, and NOTE for safety.
Lists safety warnings for installation and use, including placement, power, and cable safety.
Covers machine placement and safety requirements for electrical connection.
Provides instructions for water connection, hardness, and initial machine startup.
Detailed steps for brewing espresso, including filling, tamping, and dispensing.
Instructions for steaming and frothing milk using the steam wand.
Guides on adjusting grinder settings for coffee fineness and dose quantity.
Guides on how to customize coffee dose volumes for each drink button.
Guides on how to set the desired operating temperature for the group boiler.
Details restoring factory defaults and explains thermostat alarm messages.
Describes faults related to flow meter, time-out alarms, and probe disconnections.
Lists causes and solutions for the machine failing to start or steam wand not dispensing.
General| Number of Groups | 2 |
|---|---|
| Group Head | E61 |
| Boiler Material | Stainless Steel |
| Voltage | 220-240 V |
| Steam Wand | Yes |
| Hot Water Dispenser | Yes |
| PID Temperature Control | Yes |
| Pre-infusion | Yes |
| Type | Espresso Machine |
| Boiler Type | Heat Exchanger |
| Pump | Rotary |
| Water Supply | Direct Connection |
To Next Page