Exposure 1010 User Manual

high fidelity engineering
since 1974
Ensure your unit is switched off and that the volume
control knob is at its minimum.
Please note that your 1010 Integrated Amplifier
may take up to 48 hours to “run-in” before reaching
its optimal performance. Each subsequent “run-in”
will then take about 30 minutes.
The Exposure 1010 Integrated Amplifier is fitted
with an over current sensor which will switch off the
speaker output in the event of a speaker wire short
circuit or excessive current. To reset the output,
switch off the Amplifier for 5 minutes.

Exposure 1010 Specifications

General

Brand	Exposure
Model	1010
Category	Amplifier
Language	English

Summary

Installation

Front View and Initial Setup

Connect mains cable and set volume to minimum before powering on the amplifier.

Rear View and Connections

Details for connecting source components via RCA inputs and tape output.

Loudspeaker Connections

Instructions for correctly connecting left and right loudspeakers to the amplifier.

Operation

Basic Operation Steps

Guide to turning on the unit, adjusting volume, and selecting audio sources.

Remote Control Functions

Explanation of how to use the HS-102 remote control for various amplifier functions.

Safety and Precautions

General Safety Warnings

Critical safety instructions covering electrical hazards, liquid exposure, and proper handling.

Usage Cautions

Guidelines to prevent damage, ensure longevity, and maintain performance.

Technical Specifications

Exposure Warranty Policy