Exposure 2010S2 User Manual

<< Manual Tune down one step, press and hold for SEEK tuning
Manual >> Tune up one step, press and hold for SEEK tuning
Previous Previous preset in list (in MENU mode, Previous item in list)
Next Next preset in list (in MENU mode, Next item in list)
Menu Press to enter MENU mode, Press NEXT or PREVIOUS for
desired item, Press DISPLAY to select and press MENU
again to exit
Display Press for display ON/OFF (in MENU mode select desired
item)
1 Installation
2 Amplifier Connection
The Exposure 2010S2 FM Tuner : Back View
Analogue Output
• Connect RCA Phono sockets to appropriate line input on the amplier.
• Make sure right and left channels are properly connected.
(Right channel is marked in red)
4 Function Controls
5 Remote Control
Press the black Tuner button on the remote control before using the grey
function buttons, otherwise the remote will not operate the FM Tuner.
1~9,10+ Presets stations 1 to 18. Press +10
rst followed by 0-8 to select
presets 10-18
Display Press once to turn display o. The
display will stay o until another
button is pressed. Press again to
turn it back on.
PREV Select Previous preset
NEXT Select Next preset
<SEARCH> SEEK tune up or down
high delity engineering
since 1974
Thank you for purchasing the Exposure 2010S2 FM Tuner.
FM TUNER
Quick Start Mods
HS-101 Exposure System Remote Control
(batteries included)
Before you start
Contents:
Mains cable
For optimum performance,
use Exposure speaker cables with your Exposure equipment.
Exposure 2010S2 FM Tuner
b) Connect to the mains outlet on the wall. DO NOT
switch on until all input and output connections are
made.
Please note that your Exposure 2010S2 FM Tuner
may take up to 48 hours to “run-in” before reaching
its optimal performance. Each subsequent “run-in”
will then take about 30 minutes.
a) Connect the mains cable to
the IEC mains input socket.
3 Operation
Ensure that the volume control knob or your amplier is set to minimum.
The Exposure 2010S2 FM Tuner : Front View
The display will illuminate.
The LED power indicator will light up.
Press power switch.
Antenna
• For best performance connect to a roof mounted antenna or cable
distribution system.

Exposure 2010S2 Specifications

Power

mains supply voltage	110/120V or 220/240V
frequency	50/60Hz
power consumption	<25 VA

Tuning Specifications

output level	700mV for 75KHz deviation, 1KHz
frequency response	20Hz, -1dB, 15KHz, -3dB, ref 1KHz
tuning range	87.5 - 108MHz in 50KHz steps

Weight and Dimensions

dimensions	90 mm x 440 mm x 300 mm
nett weight	5 kg
gross weight	7 kg

Summary

Installation Guide

Amplifier and Antenna Connections

Analogue Output Connection

Connect RCA Phono sockets to appropriate line input on the amplifier. Ensure correct channel connection.

Antenna Connection

Connect to a roof-mounted antenna or cable distribution system for best performance.

Basic Operation

Front Panel Controls

Tuning and Menu Navigation Controls

Controls for manual tuning, presets, menu navigation, and display functionality.

Remote Control Operation

Remote Control Functions

Instructions on using the remote control, including button functions and activation sequence.

Extended Setup, Safety, and Specifications

Extended Tuning and Menu Options

Detailed guide to tuning, presets, and menu options for advanced setup and customization.

Safety Precautions

Important safety warnings regarding electrical shock, liquid exposure, and proper usage.

Technical Specifications

Key technical details including output level, frequency response, dimensions, and power supply.

Warranty Policy and Claims

Information on the warranty coverage, duration, and procedures for making a claim.