480846 V2.3 7/09
11
Data memory
The meter includes a non-volatile data memory that can store a maximum of 99
measured values.
Storing individual measured values
MEM
The current memory location number appears in the lower right small display.
Once you press the
MEM key, it will store a displayed value and increment the memory
location by one. Each flash of the “
” symbol display indicates one reading has been
stored. When the memory location number shows “99”, to indicate the manual data
memory is full, the user must clear the entire contents of the data memory before storing
new values.
Reading individual measured values
Z
Y
X
Exit
Entry
Reading mode indicate
Reading memory location
X
Y
Z
1. Press
READ key, the display shows “ ”(reading mode).
2. Press ▼ or ▲ key to select the desired memory location.
3. Press the
UNIT key to select the desired reading units.
4. Press the
XYZ/CAL key to select the desired sensor axis reading.
5. Press the
READ ► key to exit.
To Next Page
Need help?
General
