Extech Instruments BR200 User Manual

9 BR200-BR250-KITS_en-GB_v9.1 3/20
Hook, mirror, and magnet accessories for the BR200
The supplied BR200 accessories (mirror, hook and magnet) all attach to the camera in the same
manner. Refer to the diagrams below. Note that these accessories are not compatible with the
BR250-4.
Hook, mirror, and magnet accessories for the BR250
The supplied BR250 accessories (mirror, hook and magnet) all attach to the camera in the same
manner. Position an attachment into the hole in the camera head area and then slide the rubber
sleeve over the attachment shaft as shown in diagram below. Note that these accessories are
not compatible with the BR250-4.
RESET button on monitor
If the Monitor does not power ON, or if it powers OFF during use, observe the steps below:
1. If connected, undock the monitor from the camera controller.
2. Connect the AC adapter to the monitor and to an appropriate AC power source.
3. Locate the Reset port on the rear of the monitor (labeled Reset).
4. Using a non-metallic tool, press and hold the Reset button for 5 seconds and then release.
5. Leaving the AC adapter connected to the monitor, power the monitor ON.
If the monitor powers ON, allow it to fully charge (up to 2 hours) before removing the AC
adapter. If the monitor does not power ON, repeat the above steps. If, after two attempts to
reset the monitor, the monitor still does not power ON, please contact Technical Support.

Extech Instruments BR200 Specifications

General

Brand	Extech Instruments
Model	BR200
Category	Analytical Instruments
Language	English