CL200 V6.0 06/05 5
Storing Readings
1. Press the MODE button to store a reading. The storage location
number will be displayed followed by the stored reading and the
“HOLD” indicator.
2. Only one reading can be stored during the 120 second measurement
cycle.
3. Press the MODE button again to return to normal operation.
4. If more than 15 readings are stored, previously stored readings
(starting with number 1) will be overwritten.
Recalling Stored Readings
1. Press the CAL button and then press the MODE button immediately
after CAL is displayed; a location number (1 through 15) will flash.
2. The last stored reading taken will be displayed first. To scroll through
the stored readings, press the MODE button. The location number is
displayed first, followed by the reading stored in that location.
3. To exit the storage mode, press the CAL button and the CL200 will
return to normal operation.
Note: If the batteries are removed all stored readings will be lost.
Changing the Temperature Units
Press and hold the CAL button for approx. 3 seconds to change the
temperature units.
Auto-Power OFF
The auto power off feature automatically shuts the CL200 off 10 minutes
after the last keypress.
Low Battery Indication
When the batteries become weak the “BAT” icon will appear in the
display. Refer to the Maintenance section for battery replacement
information.
To Next Page
Loading...
Need help?
General
