Need help?Do you have a question about the Extech Instruments CG204 and is the answer not in the manual?
General| Brand | Extech Instruments |
|---|---|
| Model | CG204 |
| Category | Test Equipment |
| Language | English |
Steps for performing coating thickness measurements using reference films and substrates.
Accesses calibration functions, including enabling/disabling and deleting zero calibration data.
Controls calibration utility access and deletion of zero calibration data.
Lists and describes Zero Point, One Point, and Multi-Point calibration methods.
Steps to prepare the meter and environment for calibration.
Step-by-step guide to perform zero calibration on uncoated substrates.
How to perform a range calibration using reference films.
Method for performing sequential single-point calibrations for higher accuracy.
Method for calibrating on shot-blasted surfaces considering roughness.
Lists common error codes and their meanings for troubleshooting.
Detailed specifications for both Ferrous and Non-Ferrous sensor probes.
Describes the magnetic induction and eddy current principles used.
Specifies the measurement ranges for different units and probe types.
Details the accuracy percentages for various measurement ranges.
Specifies the measurement resolution for different ranges and units.
To Next Page