Need help?Do you have a question about the Extech Instruments MA250 and is the answer not in the manual?
General| Type | Clamp Meter |
|---|---|
| Power Supply | 9V battery |
| AC Current Resolution | 0.1A |
| DC Voltage Resolution | 0.1V |
| AC Voltage Resolution | 0.1V |
| Resistance Resolution | 0.1Ω |
| Continuity | Yes |
| Diode Test | Yes |
| Data Hold | Yes |
| Max/Min Hold | Yes |
| Resolution | 0.1A |
| Display | LCD |
| DC Voltage Range | 600V |
| AC Voltage Range | 600V |
| Display Count | 2000 |
| Jaw Size | 1.2 inches |
| Measurement Range | AC Current, DC Voltage, AC Voltage, Resistance |
Explanation of safety symbols used in the manual and on the device.
Definitions of IEC CAT I, II, III, and IV for safe electrical measurements.
How to use the NCV detector and safety precautions for its use.
Procedure for measuring AC current using the clamp meter jaws.
Steps for measuring voltage, frequency, and duty cycle with the meter.
How to perform resistance, diode, and continuity tests.
Instructions for measuring capacitance with the clamp meter.
Procedure for measuring temperature using a Type K probe.
To Next Page