Extra 200 - Page 246

CHAPTER 51
PAGE 3
EXT
RA - FLUGZEUGBAU GmbH
SERVICE MANUAL EXTRA 200
PAGE DATE: 1. July 1996
51-00-00 GENERAL
51-00-01 Access Panel Identification
For the Extra 200 all removable covers and fairings are
defined as access panels (refer to Figure 1 and the adjacent
chart). If maintenance or repair is not restricted to a small
area it is advisable to remove all access panels before
beginning work or checks.
N O T E Access panels partly overlap. Remove the front panels
first.
All panels are screwed.
For the removal/installation of the wing tip panels refer to
Chapter 57.
Prior to unscrewing of the air inlet screen remove bottom
half of the engine cowling not to lose the attachment stopnuts
and washers.
Main Fuselage Cover Removal/Installation
1 Remove the canopy per Chapter 53.
2 Remove the front instrument panel per Chapter 31 (if
installed).
3 Remove the rear instrument cover per Chapter 31.
4 Disconnect the electrical wiring from the single strobe
light.
5 Remove the rear canopy hinge.
6 Remove the center tank filler neck attachment screws.
7 Remove engine cowling attachment screws and remove
engine cowlings.
8 Remove the main fuselage cover attachment screws and
remove the main fuselage cover.
9 Install in reverse sequence of removal.