CHAPTER 51
PAGE 31
EXT
RA - FLUGZEUGBAU GmbH
SERVICE MANUAL EXTRA 200
PAGE DATE: 1. July 1996
51-70-06 Painting of Composite Parts
W A R N I N G Coating materials may cause sensitization by inhala-
tion and skin contact. Hardeners and coating materials
ready for use can have an irritant and sensitizing effect
upon the skin and respiratory tracts and cause allergic
reactions.
W A R N I N G Provide for a continuous supply of fresh air during and
also after the application, do not inhale the vapours and
wear a breathing mask during the spray application of
these materials. Persons suffering from an allergy or
being prone to diseases of the respiratory tracts must
not get in contact with coating materials.
Refer to the manufacturer technical information sheet!!
After curing cycle the surface of repared area can be sanded
with sandpaper (80 grade). Indentations are filled with white
polyester filler. Subsequently achieve a surface as uniformly
rough as possible using a finer dry sandpaper
(150 or 320
grade). Prior to paint application, the surface of the repair
area must be cleaned thoroughly of all sanding dust, separation
compounds and other foreign materials. Subsequently apply
Glassodur Rapid Filler with a spray gun.
N O T E The Rapid Filler must be completely dry before the cov-
ering paint can be applied.
For the final sanding, use 400 grade wet sandpaper to achieve
a smooth clean surface. Allow surface to dry. Paint application
of Glassodur-Pur-Acryl-Lack AD/AE 21 two component
acryl paint is performed with a spray gun.
Paint can be mixed with small quantities of reducer. After
completion of the painting, polish the repair area.
REP
AIRS
To Next Page
Loading...
