30
7. FALO’ 1XLP, FALO’ 1CP and FALO’ 2CP
As you can see in the photograph below, our FALO’ 1XLP, FALO’ 1CP and FALO’ 2CP models are
provided with a convenient drawer for pellet feeding, so there is no need to disassemble any part
of the stove to refill the pellets.
In the FALO’ 1XLP, FALO’ 1CP and FALO’ 2CP models the position of certain parts has been
changed to make access easier.
As you can see in the photographs, these parts are:
• bipolar switch
• thermostat 85°C
• DB9 connector for serial interface
To access these parts, therefore, you need only open the pellet feeding drawer and the three
components will be visible on the inside right.
To Next Page
Loading...
