Extraflame DUCHESSA IDRO - Page 34

USER PARAMETERS
34
Chapter 10
Parameter 6 (D2=UT 6( ashing); D1=E.g. “22:00:00”]
Use buttons 2 or 3 to set “22:00”, which corresponds to the switch-o time of the 2nd time span. To con rm
and continue programming, press button 5.
Press button 4 to go back to the previous parameter.
Parameter 7 (D2=UT 7( ashing); D1=E.g. “OFF 1”]
Activate the second time span only Saturday and Sunday. To do this use keys 2 and 3 in the following
way:
a. key 3 - scroll the various days
b. key 2 - enable/disable (ON/OFF) the 1st time span for that day
Example:
Day Initial value Function key 2 Final value Function key 3
MONDAY OFF 1 OFF 1 D ON 1 and vice versa OFF 1(time deactivated) Go to next day
TUESDAY OFF 2 OFF 2 D ON 2 and vice versa OFF 2(time deactivated) Go to next day
WEDNESDAY OFF 3 OFF 3 D ON 3 and vice versa OFF 3(time deactivated) Go to next day
THURSDAY OFF 4 OFF 4 D ON 4 and vice versa OFF 4(time deactivated) Go to next day
FRIDAY OFF 5 OFF 5 D ON 5 and vice versa OFF 5(time deactivated) Go to next day
SATURDAY OFF 6 OFF 6 D ON 6 and vice versa ON 6(time span active) Go to next day
SUNDAY OFF 7 OFF 7 D ON 7 and vice versa ON 7(time span active) Go to next day
To con rm and continue programming, press button 5.
Press button 4 to go back to the previous parameter.
Parameter 8 (D2=UT 8( ashing); D1=E.g. “OFF”]
Set at “OFF” using buttons 2 or 3, which is found before the time “00:00”, in a way to disable the switch-on
of the 3rd time period.
To con rm and continue programming, press button 5.
Press button 4 to go back to the previous parameter.
Parameter 9 (D2=UT 9( ashing); D1=E.g. “OFF”]
Set at “OFF” using buttons 2 or 3, which is found before the time “00:00”, in a way to disable the switch-o
of the 3rd time period.
To con rm and continue programming, press button 5.
Press button 4 to go back to the previous parameter.
Parameter A (D2=UT A( ashing); D1=E.g. “OFF 1”]
At this point the values introduced in this parameter have no value as the ignition and switch-o of the 3rd
time span have been disabled.
To con rm and continue programming, press button 5.
Press button 4 to go back to the previous parameter.
Press button 1 to escape.
N.B.: The relative indicator light on the control board will switch on when the weekly programmer is active
(see display table description).