Summit24e3 Switch Quick Reference Guide 15
disable stpd ports <portlist> Disables STP on one or more ports. Disabling STP on one or
more ports puts those ports in forwarding state; all BPDUs
received on those ports will be disregarded.
enable ignore-bpdu vlan <name> Configures the switch to ignore STP BPDUs, which prevents
ports in the VLAN from becoming part of an STPD. This
command is useful when you have a known topology with
switches outside your network, and wish to keep the root bridge
within your network. The default setting is disabled.
enable ignore-stp vlan <vlan name> Configures the switch to ignore the STP protocol, and not block
traffic for the VLAN(s). This command is useful when multiple
VLANs share the same physical ports, but only some of the
VLANs require STP protection. The default setting is disabled.
enable stpd {<stpd_name>} Enables the STP protocol for one or all STPDs. The default
setting is disabled.
enable stpd ports {<portlist>} Enables the STP protocol on one or more ports. If STPD is
enabled for a port, bridge protocol data units (BPDUs) will be
generated on that port if STP is enabled for the associated
STPD. The default setting is enabled.
show stpd {<stpd_name>} Displays STP settings.
show stpd <stpd_name> ports <portlist> Displays the STP state of a port.
unconfig stpd {<stpd_name>} Restores default STP values to a particular STPD or to all
STPDs.
Command Description
To Next Page
Loading...
