Extreme Networks Summit Summit24 Quick Reference Guide

2 Summit24e3 Switch Quick Reference Guide
config timezone <gmt_offset> {autodst |
noautodst}
Configures the time zone information to the configured offset
from GMT time. The format of gmt_offset is +/- minutes from
GMT time. Specify:
■ autodst — Enables automatic Daylight Savings Time
change.
■ nosautodst — Disables automatic Daylight Savings Time
change.
The default setting is autodst.
config vlan <name> ipaddress <ip_address>
{<mask>}
Configures an IP address and subnet mask for a VLAN.
create account [admin | user] <username>
{encrypted} {<password>}
Creates a user account. This command is available to
admin-level users and to users with RADIUS command
authorization. The username is between 1 and 32 characters, the
password is between 0 and 16 characters.
create vlan <name> Creates a VLAN.
delete account <username> Deletes a user account.
delete vlan <name> Deletes a VLAN.
disable bootp vlan [<name> | all] Disables BOOTP for one or more VLANs.
disable cli-config-logging Disables logging of CLI commands to the Syslog.
disable clipaging Disables pausing of the screen display when a show command
output reaches the end of the page.
disable idletimeouts Disables the timer that disconnects all sessions. Once disabled,
console sessions remain open until the switch is rebooted or you
logoff. Telnet sessions remain open until you close the Telnet
client.
disable ports <portlist> Disables a port on the switch.
disable ssh2 Disables SSH2 Telnet access to the switch.
disable telnet Disables Telnet access to the switch.
enable bootp vlan [<name> | all] Enables BOOTP for one or more VLANs.
enable cli-config-logging Enables the logging of CLI configuration commands to the
Syslog for auditing purposes. The default setting is enabled.
enable clipaging Enables pausing of the screen display when show command
output reaches the end of the page. The default setting is
enabled.
enable idletimeouts Enables a timer that disconnects all sessions (both Telnet and
console) after 20 minutes of inactivity. The default setting is
disabled.
enable ssh2 {port <tcp_port_number>} Enables SSH2 Telnet sessions. By default, SSH2 uses TCP port
number 22.
enable telnet {port <tcp_port_number>} Enables Telnet access to the switch. By default, Telnet uses
TCP port number 23.
history Displays the previous 49 commands entered on the switch.
Command Description

Extreme Networks Summit Summit24 Specifications

General

Brand	Extreme Networks
Model	Summit Summit24
Category	Switch
Language	English